The XT-ME Mastering Equalizer is Harrison’s fastest, most precise, and most transparent EQ for finalizing your mixes.

The XT-ME has 30 bands of equalization. The filters provide a “flat top” response, meaning: if you boost 2 adjacent bands, the gain between the bands will be consistent. (unlike a traditional graphic eq, where 2 adjacent filters will create a camel-hump)

Each band has approximately 1/3 octave bandwidth. Combined with the flat-top passband between bands, this makes the XT-ME a highly desirable tool for mastering your final mix.

To adjust the eq, simply click anywhere and drag to “draw” the desired EQ curve. Because of the broad and even pass-band between bands, “what you see is what you get”.

It is possible to adjust a single band (like a graphic eq) by clicking in the band and dragging up/down. Or point your mouse at a single band and use the mouse-wheel to adjust only that band.

Hold “Shift” and drag across the EQ to reset the bands to 0dB.

Trim: This is a clean volume control that adjusts the output level. If you use a lot of EQ “cuts” then you may need to increase this to match the level. And vice versa.

Filters: A low-pass filter and high-pass filter are provided. Click the green button to enable the filter, and adjust the slider to move the cutoff frequency.

Momentary Bypass: Click and hold this button to momentarily defeat the EQ. It is a good idea to use the Trim control to adjust the volume of the EQ’d signal so you can compare the effect of the EQ, and not just the level difference caused by the EQ.


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment